Need a ruler in ideamaker

Please post your suggestions for software changes here
santro
Posts: 7
Joined: Wed Aug 28, 2019 7:08 am

Need a ruler in ideamaker

Postby santro » Fri Sep 06, 2019 1:46 pm

The lack of a way to measure an object in ideamaker is very frustrating. You can scale in all direction but you have no idea what size you have scaled to
Please put a way to measure in to the software

User avatar
Jay_Omega
Posts: 15
Joined: Wed Dec 26, 2018 2:37 am

Re: Need a ruler in ideamaker

Postby Jay_Omega » Sun Sep 08, 2019 6:14 pm

If you click on the object then select the 'scale' tool, it will show the x-y-z dimensions of the part.

I've found that to be pretty helpful.

santro
Posts: 7
Joined: Wed Aug 28, 2019 7:08 am

Re: Need a ruler in ideamaker

Postby santro » Wed Sep 11, 2019 1:50 pm

Tried that but they are far from accurate, scaled up so x so size increased by 10mm printed and it was no where near it..

User avatar
Vicky@Raise3D
Posts: 5525
Joined: Fri Mar 25, 2016 3:54 am

Re: Need a ruler in ideamaker

Postby Vicky@Raise3D » Thu Sep 12, 2019 7:21 pm

Would you like to advise more information about the inaccurate issue you meet? The measurement is not accurate or the print result is not good enough for you?
If any picture available to explain the problem you are facing with, it will help a lot.


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests