PID for Bed

[Az3Dip]

I have Pro3 and E2.
Please make it possible to select and calibrate the PID control for the bed. I am in Ukraine, now there are big problems with electricity. Printers are connected through UPS. As far as I can see, the tables are heated through the bangbang. Because of this, the load on the UPS jumps a lot, and I can connect much fewer printers than if everyone had a PID controlled bed.

[Proschi3d]

Hello,
I converted my E2 to a Duet 3 mini.
Since I have the possibility to do PID at the table.
Even otherwise, the upgrade only brings advantages.

https://forum.raise3d.com/viewtopic.php ... 0&start=60