Official Raise3D Community

Good! Mine is still in the box, since Christmass. I don't have Canvas Hub either. Is it hard to adjust and operate ? Do you have pictures that you would like to share? In Canvas, what is the setup? Thanks, Luc.

Has anyone been able to setup palette 2 with a raise3d N2?

Thank you for the information. I bought 2 Lokbuild with N2 plus cut dimensions.

Thank you very much! This is very kind. I had great success with Lokbuild. But, after trying many build surfaces (PrintinZ, Buildtak, etc.... ) the best is the EZ-Stik Hot from GeckoTek. Yes, I need to make some adjustments, for dialing in the settings with ABS plus. http://forum.raise3d.com/viewtop...

Good for you!

Where are you from?

I have the same problem or retraction. The way I solved it for now is to increase the minimal travel distance. It work for me.

After contacting support, it appears that I have an early batch of the filament runout sensor. This could be the source of the issues that I have been having. They are going to replace my early unit runout sensor with the latest version. But, I think that it is also a firmware problem. Don't you thi...

Wow!

Would you like to share some pictures of the wiring on your motion board for the run-out sensor with our technicians at help.raise3d.com? Hi Vicky, Here a picture of my motion board. I wrote to help.raise3d. Steven U answered me : Unfortunately, some translucent filaments may not be detected when p...

I have the same error… What is the cause and the solution please? I found that the Run-out sensor does not like my Raise3d Yellow PLA filaments. It don't detect it ( like transparent filament…).And if I turn off the Detector, after a while, the error message appear and stop to print. Do I have a bad...

Korni wrote:Hello, is there news or information about the integration of Palette 2 Pro and Raise3D Pro2 printers?????

Yes? I Will received my Palette 2 pro soon. ... for my N2 plus.

You are not alone. I have the same problem since a year now. Unfortunately, Raise3d did not gave me any solution.
Before updates, it was working well.

I don't think so. This is why I whant to draw another that fit the N2 dual. When I will have time.

Casale8 wrote:No ma'am. The Bed does not stop at the stopped height, the bed moves down to about the middle of the available Z. Almost as if it were intended to offer our hands more room to remove the model from the bed.

I have the same observation. It is 4 inches lower than before the last update.

pearson222 wrote:It will not connect to any wireless network.

Same for me. No WI-FI since two firmwares updates... And no solution.

tulsah wrote:Has anyone in Canada received there's yet?

Mine is in Montreal at the custom border at Dorval since a week!

For me, it is since the "updater_0_9_7_1509.raisepack".

Thanks

Alex M. wrote: Did anyone else's issues start after upgrading the Touchscreen firmware?

Yes I have the same problem after an update see topic viewtopic.php?f=3&t=5957#p25268
I wrote To Raise support, but it does not tell me. So I don't have wifi for now.

The use of 3D printed parts in new products is becoming more and more common. If there is 3d printed parts made by Raise3d, I hope they will put more quality on the material used and a better external finish. Because I have seen ugly parts sometime in the past. And if we look on the pictures of the...