Official Raise3D Community

How to export it?

Almost.

But only after a power failure? At normal usage not problem at all...

But it has. The second time, not touchscreen responds... and freezes after the restart at booting startup screen.

I can by wireless keyboard... after a resumed job and restart everything back to normal. Second time. Sofware driver bug.

Vicky. That is not the issue. The main bug is that touch panel doesn't respond for touch.... after power failure... you can't resume... you can't do nothing...

Touch screen not responding after power failure ... you can't restore your work... hard reset - soft reset not touch screen reaction. Only Bluetooth keyboard works... Almost second restart touch panel boots and freezings. After finished the job and restart everything back to normal and touchscreen r...

Always, do it with right nozzle and bed temp... but only for filament... you should plan to use.

Beware if you want to clean it... after high temps, is easy to tear it apart...

Devildesigns.

I was try to start wit IM. But no luck. Chaos software. Too much options injected in few windows without logic.

I was try alcohol wit Buildtak. And 50% water mixture with isopropyl works good. But Buildtak sucks. Bubbles.

I'm using PEI with ABS, Polycarbonate and without any problem. They came off easily. Try do adjust Z-axis a little bit higher... or use Buidtak 90 degrees spatula. This tool looks stupid and weird, bor works perfectly.

Use heat gun blower and sharp tools. Slowly.

Right idea

Z-hop. You should use this feature and adjust also Z-axis higher. For example 0.25mm. That way.

Sliding sleeve to replace...

Z-axis calibration and Z hoop value. And few more adjustments...

Not. You should to lubricate it.

Ok, first you should te remove tubes from the extruder or use oil. Friction totally stops filament is not possible to pull it out from spool with tubes... second warping... I'm using blue tape or Kapton but still, after few layers, it can pell of at corner... Any ideas?