Official Raise3D Community

Pro2: Print finish screen, wrong filament usage Attachment(s)
by atelieroechsli » Fri Jan 24, 2020 8:32 pm » in Pro2 Series

Printing Issue Attachment(s)
by MMER1116 » Thu Jan 23, 2020 8:54 pm » in Printing Settings

modifiers Attachment(s)
by DeX » Thu Jan 23, 2020 9:36 am » in Software

Experiencing stringing. Hatcbox PLA. Creality Ender 3.
by artfullyrogue » Wed Jan 15, 2020 6:05 pm » in Software

Using Ultimaker Cura with a Pro2
by Vagulus » Sat Jan 11, 2020 12:36 am » in General

Left Nozzle Extruder Motor Will Not Move (not jam related)
by Kraken3d » Mon Jan 06, 2020 7:23 pm » in Pro2 Series

Filament swap?
by peeknic » Wed Dec 04, 2019 1:51 pm » in Feature requests, ideas, wishes

Pro2: Hardware Suggestions
by 87ninefiveone » Tue Dec 03, 2019 3:58 pm » in Hardware

Raise3D Pro 2 nozzle clogs using IONIC filament
by Circuit_Jack » Sun Nov 24, 2019 8:09 pm » in General

Life-sized Meowth Attachment(s)
by Jay_Omega » Wed Nov 20, 2019 2:44 am » in User's Gallery

changing flow rate settings in filament settings has no effect.
by Dreetie84 » Thu Nov 14, 2019 5:26 pm » in Software

Extruder Board cable connector
by jeffarazzi » Wed Nov 13, 2019 9:16 pm » in N Series

Autocalibrator
by mike » Tue Nov 12, 2019 6:05 pm » in Hardware

Installing a Timer
by Kobar » Tue Nov 12, 2019 11:09 am » in Hardware

Calibration of line length
by mike » Tue Nov 12, 2019 8:25 am » in Feature requests, ideas, wishes

Resume at Step X of gcode
by mike » Tue Nov 12, 2019 8:22 am » in Software

Cura 4+ with N2 Single
by mrmdsims1 » Sat Nov 09, 2019 2:07 am » in Software

There is not enough available storage to print
by gridnevcnc » Fri Nov 08, 2019 9:33 am » in N Series

Invalid Model Attachment(s)
by Vagulus » Sat Nov 02, 2019 12:22 am » in General

N2 Plus Optical Sensors
by CaryC2 » Thu Oct 31, 2019 8:20 pm » in N Series

N2 Filament run-out sensor review
by bankie » Thu Oct 31, 2019 11:48 am » in Hardware

Add defined gap between perimeter start/end Attachment(s)
by Ralf95 » Tue Oct 29, 2019 4:54 am » in Feature requests, ideas, wishes

profile for an ender 5 out there?
by mikers » Wed Oct 23, 2019 11:24 pm » in Software

Advanced nozzles for Pro2
by miszun » Tue Oct 15, 2019 9:25 am » in Pro2 Series

Support anf Infill Percentages Attachment(s)
by Vagulus » Mon Oct 07, 2019 1:25 am » in General