Search found 4 matches

by smitseric
Wed Sep 25, 2019 8:17 am
Forum: General
Topic: Part Shifting Again Again and Again
Replies: 44
Views: 11299

Re: Part Shifting Again Again and Again

Hi thanks for your reply. The couplers were fine, those links are for the Pro-series and doesn't apply to my N2+ dual extruder so much. It would be great if you could send me the ones for the N2+ just in case I have to disassemble it some time. The gantry alignment instructions were fine in spite of...
by smitseric
Thu Sep 19, 2019 1:20 pm
Forum: General
Topic: Part Shifting Again Again and Again
Replies: 44
Views: 11299

Re: Part Shifting Again Again and Again

Hi Vicky, thanks for your reply. I hear no clicking noise. It moves relatively smoothly however I feel more resistance in the left third of the x axis (moving from right to left looking into the printer). Any other suggestions?
by smitseric
Tue Sep 17, 2019 2:28 pm
Forum: General
Topic: Part Shifting Again Again and Again
Replies: 44
Views: 11299

Re: Part Shifting Again Again and Again

Hi, I am having the same problem on the x-axis (motor in the back) of my N2+dual extruder. It started happening after the gantry was stuck due to nodes in the filament getting stuck before the filament monitor. It sounded like the motor was forced and could not cope with the load. Since then it shif...
by smitseric
Thu Jun 27, 2019 2:19 pm
Forum: N Series
Topic: Does Runout Sensor Detect filament not moving??
Replies: 13
Views: 2908

Re: Does Runout Sensor Detect filament not moving??

Hi, Same problem here, Just intalled it in my N2 plus dual extruder, all up do date and also lights on, but I ran 2 tests and it did not detect the filament running out, could you help?

Go to advanced search