Search found 7 matches

by planetech3D
Fri Aug 09, 2019 10:07 am
Forum: N Series
Topic: mosfet controller board to extrude
Replies: 4
Views: 633

Re: mosfet controller board to extrude

Actually it functions on controlled outputs. Knows when power limit, as soon as the motor forces a little LED lighting decreases brightness. On the permanent 12vdc with the motor the voltage drops 10.3vdc to 12.3vdc places without motor. The 12vdc control part of the control board is too limited in ...
by planetech3D
Thu Aug 08, 2019 9:06 am
Forum: N Series
Topic: every boot
Replies: 3
Views: 481

Re: every boot

I unplug the cable from the back of the printer. I have never handled the rj45 cable inside the printer. Also if I turn off the switch electrically, so the printer is no longer connected to the network, in this case it starts. If the printer is connected to my local network it will not start. I have...
by planetech3D
Wed Aug 07, 2019 10:37 am
Forum: N Series
Topic: every boot
Replies: 3
Views: 481

every boot

I have an N2 that has every boot I have to remove the network cable for which can start otherwise the boot process does not go through until the progress bar hangs and the process does not reach the user interface. If I unplug the rj45 cable, the start will happen normally. I changed the rj45 cable ...
by planetech3D
Wed Aug 07, 2019 10:22 am
Forum: N Series
Topic: mosfet controller board to extrude
Replies: 4
Views: 633

mosfet controller board to extrude

Hello, I would like to know about the controller board to extrude the mosfet for the fans "7R0 60 PEm 1602 b7 8967" can provide up to what current in 12v I would need 700mA constant and 1.3A peak. I did not find the data sheet on this precise value of mosfet. Thanks for your feedback https...
by planetech3D
Wed Sep 12, 2018 10:16 pm
Forum: N Series
Topic: Touch screen
Replies: 2
Views: 765

Touch screen

Hello, I bought a used N2 +. The former owner has not used it for more than 6 months, at startup the left touch zone no longer works. I dismounted and passed the slicks to the electrical contact product. It still does not work. According to you this is a known failure on the screens, is there a cali...
by planetech3D
Mon Feb 05, 2018 2:17 pm
Forum: Software
Topic: the version of github contains errors
Replies: 3
Views: 938

Re: the version of github contains errors

I found my problem had to remove comments that I did not expect.
This is a basic version that must be adapted to the version of its Raise3D.
I apologize I spoke too fast.
by planetech3D
Mon Feb 05, 2018 9:54 am
Forum: Software
Topic: the version of github contains errors
Replies: 3
Views: 938

the version of github contains errors

Hello, I would like to make changes to the available firmware. On github "https://github.com/Raise3D/Marlin-Raise3D-N-Series" I tried to apply the minor modifications, once the deposited in the motherboard, bizarre behaviors appear on the LCD screen, ghost temperatures come for a moment an...

Go to advanced search