Search found 2 matches

by Larry_MOG-TX
Tue Sep 10, 2019 7:35 pm
Forum: Printing Settings
Topic: Voids in Sub-layers
Replies: 3
Views: 76

Re: Voids in Sub-layers

Howdy! Does the "Top" refer to the highest point in the Z? As my part has the compass rays and numbers above the top surface (50 layers) and I mentioned the voids were 50 layers thick then I could have set for 100 layers for the Top Solid, right? Brings up another question. When putting a ...
by Larry_MOG-TX
Sun Sep 08, 2019 7:46 pm
Forum: Printing Settings
Topic: Voids in Sub-layers
Replies: 3
Views: 76

Voids in Sub-layers

Howdy - I am trying to create a part that is basically a 100mm diameter disc that's 10mm thick with some short (1.25mm) protrusions Lines and text. I tried a few times to print with high resolution settings, but the part would fail on the top layers. I have printed with default settings and have a s...

Go to advanced search