Official Raise3D Community

Thank you jet guy for the information. none of this made sense to me either but now that you mentioned the wall socket that must be the issue because i just moved the printer into my garage. Thanks for all the help everyone!

Hey Everyone, Im on my 3rd power supply now after blowing 2 up. I started a 60 hour print and at about 40 hours my power supply blows something and turns to junk. My Printer has bond tech extruders and panucatts stepper motor drivers for X and Y but that never seemed to be a problem with my prints. ...

I recently switched to the bond tech dual for my n2 plus and it has been working great. until yesterday about 20 min into printing the raft for my part the extruder seems to be grinding the filament and extruding nothing, almost as if it is clogged and can't push any out. so i took the hot end all a...

Hey Vicky are the Micro stepping switches set default in the on or off position?

Hi there, I recently bought 2 panucatts stepper motor drivers to replace my X and Y Drivers and I'm not sure if i set the micro stepping switches right, Ive read that they need to be set at 1/16th. Also i seem to have reverse movements when i tried to move my extruder to the home position. if anyone...

I do have the same trouble on 2 brand new raise N2 plus. Shifting even usign a big ZHOP, no wrapping, but always at the same emplacement on the print. I suspect IDEAMAKER to generate a BAD GCODE or something close to it. I'm strugeling this this issue for more than 1 month. Some of my big print (U ...

After a lot of Forum Reading and poor help from the raise3d engineers (who never even replied to my last email) and rolls of filament later, i have finally solved the problem. First i Upgraded to the Bondtech Dual Extruders. Awesome Product and much lighter then the stock set up. I realized i was ex...

yes seems to be in the Y direction everytime.

Vicky@Raise3D wrote:If it will have similar layer shifting problem with some simple structure models but can reach to the same height as the model you have problem with? Or only shifts on this model?

I Have had this happen on some other prints as well.

Do you print using just one nozzle? If so, it is a good idea to put lift second (right) nozzle up. Another thing you can try is to use the "Z-Hop"-function. You'll find that on the "Extruder" Tab after you clicked "Advanced" in the slicing settings. I have found some 0...

Casale8 wrote:Have you lubricated your shafts?

I Haven't lubricated the shafts they still seem to have grease on them

Hi there, Im new to the 3D printing world and I purchased a n2 plus a few months ago and have had it running practically every day since, learning things through trial and error as i go, but I'm stuck with a big issue i can't seem to figure out. I keep having major layer shifting on my tall prints, ...