Search found 5 matches
- Wed Sep 25, 2019 6:29 am
- Forum: Others
- Topic: IdeaMaker Slicer Problem
- Replies: 7
- Views: 3744
Re: IdeaMaker Slicer Problem
Dear Vicky I have read sorry to ask something known but I can say that what you explain is of my responsibility my problem is in fact that my piece is too strong attach to the raft and i think that it was the raison .You don't in your raisonnement take in care the flow rate of the first layer I will...
- Fri Sep 20, 2019 2:44 am
- Forum: Others
- Topic: IdeaMaker Slicer Problem
- Replies: 7
- Views: 3744
Re: IdeaMaker Slicer Problem
Dear Vicky for the semi colon I know that I don't think you understand what I mean (my english is so poor) my problem is the gap between model and Raft. Have you notice that the GCode ask the prinetr to go back of .4 mm (decrease the z value) It was at 2.62 and ask to go to 2.42 .The print has been ...
- Thu Sep 19, 2019 5:54 am
- Forum: Others
- Topic: IdeaMaker Slicer Problem
- Replies: 7
- Views: 3744
Re: IdeaMaker Slicer Problem
Dear Vicky Sorry but i hope this is not the problem In all layer you can see that ;Z:2.350 and the order to the z motor is G0 F1500 Z2.250 This is the -0.1 General ofset I prefer software ofset instead of screwing to adjust my bed . Have you pay attention that Layer 1 is 2.35 ie (2.25) and layer 0 i...
- Fri Sep 13, 2019 2:29 pm
- Forum: Others
- Topic: IdeaMaker Slicer Problem
- Replies: 7
- Views: 3744
IdeaMaker Slicer Problem
Dear All Where did I make a mistake. Printer R2+Hot I have problem with the gap between Raft and Layer 0 I look the Gcode made by ideaMaker Ver 3 4 2 3140 and I am very surprise whith the Z value I think that I have found that the GCode ask to print Layer 0 at 2.62 and Layer1 at 2.25 which i lower W...
- Thu Sep 12, 2019 3:04 am
- Forum: Others
- Topic: Members in France
- Replies: 46
- Views: 28975
Probleme de Slicer Ideamaker
Bonjour Ou ais je faux . Imprimante R2+Hot Je regarde le Gcode que ma donner ideaMaker Ver 3 4 2 3140 et je suis surpris par les Z J'imprime sur Raft et j'ai l'impression qu'il imprime a 2.62 puis a 2.25 Ou est mon erreur ci dessous le fichier GCode épuré et je joins le total . Le fond du problème i...