Search found 6 matches

by peterbako
Mon Sep 02, 2019 9:21 pm
Forum: User's Gallery
Topic: My creations
Replies: 1
Views: 747

My creations

Hallo, I would like to show you my own design creations, which I present under the name: DESCART. I am a professional industrial designer, but these vases are my passion - my freetime activity 8-) Most of the vases are printed on a Raise3D N2plus, PLA, 0.3mm layer. I have a nice video how the vases ...
by peterbako
Tue Feb 26, 2019 7:26 pm
Forum: User's Gallery
Topic: 60 cm vase
Replies: 0
Views: 1080

60 cm vase

60 cm tall vase.

PLA, natural, 0.3mm layer height, 3 shells, 21 hours print time.
by peterbako
Wed Mar 22, 2017 9:33 pm
Forum: Hardware
Topic: How to perform a nozzle change correctly ?
Replies: 2
Views: 1521

How to perform a nozzle change correctly ?

Hi. I'm looking for instructions/tips on how to change the nozzle without breaking anything on a N2+ V2 hotend. Is it better to remove the hotend before changing nozzle? Or using the 3d printed tool to fix the heater block and just unscrew? Does is need to be hot or cold when releasing and tightenin...
by peterbako
Fri Dec 23, 2016 12:09 pm
Forum: Software
Topic: Can't use full bed, software settings over-ridden???
Replies: 18
Views: 3261

Re: Can't use full bed, software settings over-ridden???

One more question to this thread. ... I have followed several discussions about the printable area and it still isn't clear to me. .... When I home the head in XY position, the 0,0 point lies slightly outside the buildplate. Even when I start a print the extruder priming procedure occurs outside the...
by peterbako
Sun Nov 27, 2016 6:41 pm
Forum: Software
Topic: Lots of retraction on the 2 last layers ??
Replies: 4
Views: 1421

Re: Lots of retraction on the 2 last layers ??

Hi,
I noticed the same...a retraction at the end of every single line of the top layer...I found it stange but had no time to investigate the behaviour yet.
by peterbako
Sun Nov 27, 2016 6:36 pm
Forum: General
Topic: Can't power off
Replies: 4
Views: 1498

Re: Can't power off

Hi all, I sucessfully tested my new N2+ with the 20mm calibration square. Only problem is I now can't turn the printer off. The screen just stays in a flicker loop. One suggestion was to use the reset button to power off the screen. The screen blanks when the button is pressed in, as soon as I rele...

Go to advanced search