Official Raise3D Community

Thank you, Vicky. I will shoot a support ticket.

By the way, on the Motion Controller Board I saw two connectors for JTAG and SPI (?) interfaces form ATMega2560. Are they usable for checking fuse bits? Maybe the SPIEN fuse bit in ATMega2560 is disabled? (Just an idea.)

News about my problem. It seems to be a hardware problem on the motion controller board. I connected the USB serial cable from my computer directly to the motion controller board. In genaral the direct communication between Idea Maker and the Motion Controller Board works fine. Idea Maker shows me n...

Yes, I’m trying to update the officiell N2PLUS-Dual-1.1.6rev1.firm file from Raise3D homepage. Is this the wrong file? I have a Raise3D N2 Plus V2 with 2 feeders and 2 printing nozzles. When I start printing this firmware file from SD or USB memory stick, for 10 seconds I see the Message "Updat...

I'm trying to update firmware version from 1.1.1 to 1.1.6 for N2 Plus-Dual.

My last update of touchscreen software was successfuly. Version 0.9.7.1509 works fine.

hit print go to where the file is located. it should have a gear icon. touch the file and it will ask if you want to flash the firmware. I made it like this, but it breaks and the touchscreen gives me the Message: "Update failed: Update failed." The only thing I can do is pressing the &qu...

There is a letter "K" on the cold end.



What does it mean? Is the Position of the "K" important for reassembling or mounting the throat tube?