Search found 4 matches

by Ihunter74
Mon May 27, 2019 1:03 pm
Forum: Hardware
Topic: Runout sensor keeps falling off
Replies: 1
Views: 689

Runout sensor keeps falling off

I have tried several different methods of attaching the runout sensor but after a while it keeps falling off. Has anybody come up with a better way of attaching it to the N2+.
by Ihunter74
Fri Jan 20, 2017 3:51 pm
Forum: General
Topic: n2 screen not responsive sometimes
Replies: 3
Views: 1015

Re: n2 screen not responsive sometimes

I have had this issue as well and it usually get stuck at the screen prompt after a print finishes. I will try your idea Jetguy to see if it fixes that.
by Ihunter74
Sat Sep 17, 2016 6:18 pm
Forum: Hardware
Topic: X/Y home issue
Replies: 2
Views: 1415

X/Y home issue

Group, I put a ticket in for this but its the weekend and I figure it might be a bit before I hear from Raise3d. This morning I got up and pulled my latest print off the printer. I hit the X/Y home and it moved along the X axis hit the side and tried to keep going. It eventually stopped but it was w...
by Ihunter74
Mon Aug 29, 2016 1:22 pm
Forum: Hardware
Topic: Is the Raise3D N2+ a good printer? (need advice asap)
Replies: 38
Views: 9587

Re: Is the Raise3D N2+ a good printer? (need advice asap)

So I am in the same spot as the originator of this thread. I am hoping to order my first 3D Printer this week and I am stuck between the Raise3d N2+ and the GCreate GMax 1.5 XT+. Does anybody on this thread have both and can give me a good comparison of the two. I have run the numbers on both but re...

Go to advanced search