Search found 5 matches

by nano4u
Thu Jul 18, 2019 6:12 am
Forum: Software
Topic: Some issues with ideaMaker
Replies: 9
Views: 628

Re: Some issues with ideaMaker

Sounds very interesing! I am using Windows 10 64bit.
by nano4u
Sun Jul 14, 2019 4:02 pm
Forum: Software
Topic: Some issues with ideaMaker
Replies: 9
Views: 628

Re: Some issues with ideaMaker

Today I did some test prints for a direct comparison with and without z-travel move. See files attached. The photos below show the result of two different test prints, each in two versions (thick rod / thin rod). Unchanged GCode generated by ideaMaker is on the left, the only difference on the right...
by nano4u
Fri Jul 12, 2019 4:38 am
Forum: Software
Topic: Some issues with ideaMaker
Replies: 9
Views: 628

Re: Some issues with ideaMaker

Actually, I found that it is much better just to move the nozzle away by one or two layer heights vertically (0.2mm or so), then quickly move x and y, e.g. to the origin. This way the hot filament is not pulled out of the nozzle but it is rather kind of sheared off. In ideaMaker I add this to the en...
by nano4u
Thu Jul 11, 2019 5:22 pm
Forum: Software
Topic: Some issues with ideaMaker
Replies: 9
Views: 628

Re: Some issues with ideaMaker

Hi Vicky, Thanks for your response. Somehow I could not reproduce the reflex/convex issue again, although I struggled with it for quite a while :( Maybe I messed up a reflex outer wall (wall of a hole) with the inner wall of a convex shape when using low infill (then it looks like the outer wall at ...
by nano4u
Sun Jul 07, 2019 5:42 am
Forum: Software
Topic: Some issues with ideaMaker
Replies: 9
Views: 628

Some issues with ideaMaker

Hi, I am using ideaMaker now for quite a while, both for professional as well as for private purposes. I must say it has quite a few advantages over other slicers. However, a few issues I could not resolve myself, so I would be happy if anyone had suggestions for solutions or workarounds: 1) Is ther...

Go to advanced search