Official Raise3D Community

So every curve is just an adding up on short lines, where evertime the printer gets a new command for each segment, also the extruder. so perhaps something like tuning in linear/pressure advance can reduce this kind of artefact. My "Minimal Segment Length" is 0.005 mm, so is too small and...

ZombiePach, thank you for the reply and feedback about the Hyper Speed upgrade because I am also considering buying this one.

So, as said Labirynt - there is one solution - "to buy a different brand printer"

Hi! I have a new Pro3 and it has problems with the printing quality. The parts have ringing, especially with speeds higher than 40 mm/s. Ringing appears on different materials and not only on curved surfaces but also on flat ones. Here you can see a part that was printed by PLA (BASF PRO1) with an o...