Search found 3 matches

by timaga
Thu Sep 01, 2022 5:53 am
Forum: Pro3 Series
Topic: Nozzle offset issue >4mm difference in height
Replies: 3
Views: 338

Re: Nozzle offset issue >4mm difference in height

Yes, I ran the offset calibration steps on the maintenance tab. However, it stalls on the right nozzle since I can't get the nozzle to come within the feeler gage range as the left nozzle is touching the print bed.
by timaga
Sun Aug 28, 2022 7:37 am
Forum: Pro3 Series
Topic: Nozzle offset issue >4mm difference in height
Replies: 3
Views: 338

Nozzle offset issue >4mm difference in height

My Pro3 plus had been printing fine until recently. I changed my buildtak surface and ran the 64 point bed levelling program. After I updated the firmware, it looks like I have an offset issue. I cannot seem to calibrate my offsets, since the right nozzle is higher than the left by >4mm. I've tried ...
by timaga
Fri Aug 05, 2022 12:40 am
Forum: Printing Settings
Topic: ABS/TPU 100% Infill
Replies: 1
Views: 406

ABS/TPU 100% Infill

I'm printing nested cylinders in alternating materials with 100% infill, and was wondering if there is a way to make the prints faster by doing a continuous spiral for each layer instead of alternating diagonal infill like a traditional 3d print.

Go to advanced search