Search found 3 matches

by Kevin@Raise3D
Wed Jun 09, 2021 12:34 am
Forum: Printing Settings
Topic: getting closer for minis
Replies: 1
Views: 267

Re: getting closer for minis

Ok, i have been trying to get ideamaker to print minis. I have only used IM for larger parts and used cura for minis. I would like to get rid of cura and stick with one slicer if possible:) Im supper close to great minis, the issue is blobs at the start of new layers and seam hiding. I have the sea...
by Kevin@Raise3D
Wed Jun 09, 2021 12:32 am
Forum: Printing Settings
Topic: Matterhackers Pro Series PLA
Replies: 17
Views: 1854

Re: Matterhackers Pro Series PLA

This is very, very, very, very frustrating. Some PLA filaments print fine, some can't make it through a single print without filament grinding. Even with two different colors of brown from the same manufacturer (tan vs. beige) one prints fine the other, beige as shown above does not. The successful...
by Kevin@Raise3D
Wed Jun 09, 2021 12:30 am
Forum: Software
Topic: Fan control
Replies: 4
Views: 173

Re: Fan control

The HEPA filter is not only used for material odors but also small particles that can be produced while printing. For this reason, we recommend that it be in use at all times while the machine is printing. Just have to wonder why there is such a big daylight air gap up the side of it in the filter ...

Go to advanced search