Search found 5 matches

by toddanglin
Tue May 11, 2021 9:58 pm
Forum: Software
Topic: My printer connects, but refuses to accept uploads
Replies: 31
Views: 8142

Re: My printer connects, but refuses to accept uploads

Good to know, Vicky. Thanks for the reply. (And I must say, if this is not a shared support account, you are amazingly prolific and prompt on these forums. :)) Meanwhile, the printer seems to be back in business. It is accepting uploads over both the local network and from RaiseCloud. I did unbind/r...
by toddanglin
Tue May 11, 2021 7:31 am
Forum: Software
Topic: My printer connects, but refuses to accept uploads
Replies: 31
Views: 8142

Re: My printer connects, but refuses to accept uploads

What's the best way to share these logs? Over the public forums? Or via some other private channel? I did export the logs and observed a lot of repeating `[QMXCHttpReboot] state: 2` logs (every ~5 minutes for several hours). Not sure if that's relevant. There are also `CLOUD NETWORK CHECK TIMEOUT ER...
by toddanglin
Tue May 11, 2021 7:24 am
Forum: Software
Topic: What constitutes bridging in Ideamaker?
Replies: 8
Views: 3908

Re: What constitutes bridging in Ideamaker?

Thanks, Vicky! I'll have to do some more investigation. In my recent model, I had a cylinder spanning a large gap (80+ mm) parallel to the build plate (90 degrees) supported by other structures on both ends. No matter how I tweaked the settings, the slicing preview never showed bridging operations, ...
by toddanglin
Mon May 10, 2021 7:20 am
Forum: Software
Topic: What constitutes bridging in Ideamaker?
Replies: 8
Views: 3908

Re: What constitutes bridging in Ideamaker?

Just another Google searcher arriving at this thread with the same question. How do you get ideaMaker to treat a horizontal (90 degree) span between two points as a bridge?
by toddanglin
Mon May 10, 2021 4:21 am
Forum: Software
Topic: My printer connects, but refuses to accept uploads
Replies: 31
Views: 8142

Re: My printer connects, but refuses to accept uploads

Any resolutions to this problem that can be shared? I ran in to this, too. One of my E2s has stopped recognizing/accepting new jobs over the network. If I try to upload directly from ideaMaker, it just says "Upload Waiting" forever. If I upload to RaiseCloud and assign to my printer, it wi...

Go to advanced search