Search found 4 matches

by JG!
Fri May 14, 2021 12:32 am
Forum: E2
Topic: Extruders aren't zero correctly on X axis
Replies: 5
Views: 1287

Re: Extruders aren't zero correctly on X axis

I did, got the new sensor and all seems good now with homing correctly. It calibrated correctly and I was able to print the test cube no problem. I did try an IDEX print later today and it had an overlapping problem. I think it's unrelated. but will continue to monitor.
by JG!
Tue May 11, 2021 1:00 pm
Forum: E2
Topic: Extruders aren't zero correctly on X axis
Replies: 5
Views: 1287

Re: Extruders aren't zero correctly on X axis

Looks like the left extruder's X axis home sensor is shot. I noticed there is an LED in the right extruder's home sensor that is glowing, and the left extruder's not. With the go ahead from Raise3D tech support, I switch the sensors to see if I could get the left sensor to light up on the right side...
by JG!
Sun May 09, 2021 1:51 am
Forum: E2
Topic: Extruders aren't zero correctly on X axis
Replies: 5
Views: 1287

Re: Extruders aren't zero correctly on X axis

Went through to make sure all the firmware is up to date. Tried to rerun the calibrations and still the left extruder thinks it's home position is in the middle of the build plate. I also tried to roll back the firmwares but that didn't do it either. Reset everything to factory, nada. Even in the Ul...
by JG!
Fri May 07, 2021 8:40 pm
Forum: E2
Topic: Extruders aren't zero correctly on X axis
Replies: 5
Views: 1287

Extruders aren't zero correctly on X axis

Just got my E2, went through the calibration and printed the medallion that comes with the machine. That printed fine along with the offset print head multimaterial cubes. I created a few print files with ideamaker and this is where the trouble started. For some reason, the left extruder now thinks ...

Go to advanced search