Official Raise3D Community

Now is working, had to uninstall and install back again

but as you can see this is not X seconds before as you can set on the slicer. The M104 is put right on the change layer/Extruder

Vicky@Raise3D wrote:If using M109 for heating in advance, then the print will pause and waiti for heatup in mid of a print. Heating in advance for inactive extruder should be M104.

Still no success... can you try with 4.1 ? Heating in advance is not working !

it is working only if selecting "pillar mode" and not "normal", why ?

Why this big difference between S3D and IDM in support generation ?

Here the Gcode: https://we.tl/t-pvY2Q1JWuE

ok... but heating in ADVANCE is using M109 not M104. Otherwise will be useless ...

Try to enable the Heating in Advance of 60 seconds

Hi !

Just try with a simple cube 40X40 mm with 20% infill !

Hi In this version heating up in advance is not working, i can spot the M109 only when is changing the extruder and not X seconds before as usual. Is this a bug ? I tried with all of my profiles and is not working. Feature: is possible to change the extruder over the wipe tower instead on the piece ...