Search found 8 matches

by synthius
Sun Apr 10, 2016 5:04 pm
Forum: General
Topic: Buildtak
Replies: 67
Views: 21994

Re: Buildtak

On the subject of BuildTak I was planning to remove it at the first chance I got. However I have gotten used to it for the most part, while I'm still not sold on it I do admit that it tends to just work for the mid sized prints I normally print. Only real issue I have with it is the larger and none...
by synthius
Thu Apr 07, 2016 7:02 pm
Forum: General
Topic: Buildtak
Replies: 67
Views: 21994

Re: Buildtak

I've used the solutions you've described and they all have worked. Never did I say they did not work for me. I found Buildtak to work just as good/better without the hassle. Why is that so hard for you to understand?? I was simply stating these facts and you got all worked up and started spouting of...
by synthius
Thu Apr 07, 2016 5:28 pm
Forum: General
Topic: Buildtak
Replies: 67
Views: 21994

Re: Buildtak

I couldn't care less what anyone uses for a build surface, and I'm not married to Buildtak. The guy asked a simple question and I told him it was working ok for me. Another guy said it worked for him. Andy said he had release problems, which is good info to have, thanks for that. What's not so good...
by synthius
Wed Apr 06, 2016 8:04 pm
Forum: General
Topic: Buildtak
Replies: 67
Views: 21994

Re: Buildtak

and what the hell is " I expected a bit more from you Julia." My god you people never cease to amaze me. Please be sure to mentions Julias post along with your absurd comments in your podcast. I will be listening for it.
by synthius
Wed Apr 06, 2016 7:39 pm
Forum: General
Topic: Buildtak
Replies: 67
Views: 21994

Re: Buildtak

First and foremost - you didn't "simply state that I was speaking from a lack of experience with AQ". You saw the omission of AQ from my post and proceeded to belittle me for "not bothering to use it". Which is not only a blind assumption on your part but also an absurd and incor...
by synthius
Wed Apr 06, 2016 5:44 pm
Forum: General
Topic: Buildtak
Replies: 67
Views: 21994

Re: Buildtak

Ahh but I have used Aquanet and found it to be inferior to purple gluestick. None of that matters anymore since I've switched to Buildtak. If you aren't inclined to take a few minutes to set your bed height to make Buildtak work then your loss. now what to do with all this extra time? :lol:
by synthius
Wed Apr 06, 2016 4:44 pm
Forum: General
Topic: Buildtak
Replies: 67
Views: 21994

Re: Buildtak

30 may sound small but that's 30 round trips to the sink that I did not have to make to wash the glass plate of glue. 30 times that I did not have to wait for the print to pop off the glass plate while it was packed in my freezer. Many sheets of paper towel that have been saved. You will find that a...
by synthius
Tue Apr 05, 2016 4:09 pm
Forum: General
Topic: Buildtak
Replies: 67
Views: 21994

Re: Buildtak

Buildtak works great! I have printed with Blue Painters tape and Glass with purple glue-stick in the past but have since stuck with the buildtak ever since it came with my Raise3D. Yes, I found that if your first layer is smooshed to far into the buildtak then you will have a bad time. As long as yo...

Go to advanced search