Official Raise3D Community

Unfortunately, I have not found a placeholder that determines the particular extruder like PrusaSlicer or Cura:

M104 T[initial_extruder] S[first_layer_temperature] ; set extruder temp
M104 T{extruder_nr} S235 ; Set extruder temp

Hello community, concerns an IDEX printer with 2 print heads. I have stored 2 different GCodes for Start GCode in the GCode tab: 2022-12-05 17_06_49.png 2022-12-05 17_08_13.png I just can't get it to take the GCode for the right extruder, only the code for the left extruder is in the GCode file. In ...

With one solid fill shells it works, but normaly i have 3 solid fill shells in Ideamaker. I would need to work with layer heights here to changed it from 3 to one wall. Maybe something can be changed here in the future, because every slicer with 3 walls and bridges has no problems. Ideamaker is stil...

I played with Overhang Shells speed and increased the speed to 60mm/s to see the result:

In this example it seems to work.

In this example with one bridge layer, the bridge layer is not detected:


Best regards,
Juergen

Hi Vicky,
thanks for your answers.

Unfortunately I can't get any further here. In the attachment is a bridging test, where the bridging is not recognized
With another slicer (Prusa) the bridges are recognized as bridges.

Do you still have an idea here?

Best regards Juergen

Hi, I would like to print a component cooler, but I have problems with the bridge detection. The red marked parts are only recognized as thin wall and not as bridge. I can increase the value under "Minimal Extrusion Width Percentage", but it doesn't draw a proper line by the 2 small air ho...