Search found 6 matches

by poldim
Sun Sep 15, 2019 4:20 pm
Forum: Software
Topic: Dual filament printing - where are the instructions?
Replies: 2
Views: 234

Dual filament printing - where are the instructions?

I'm trying to print a single object with a mix of materials from both print heads. I tried to look in the ideamaker manual but did not find anything mentioning dual extruder prints.

So, where is this documented?
by poldim
Sat Jan 19, 2019 10:57 pm
Forum: Printing Settings
Topic: Printing directly on the bed without a RAFT?
Replies: 7
Views: 1083

Re: Printing directly on the bed without a RAFT?

If you're printing PLA without the raft, the standard PLA default profile works great. But, I've changed my bed height relative to the nozzle so that when you measure with the 0.2mm metal piece, it requires a little bit of persuading to fit between the nozzle and print bed. So the separation distan...
by poldim
Thu Jan 03, 2019 9:07 pm
Forum: Software
Topic: Home Assistant component for Raise3D
Replies: 0
Views: 548

Home Assistant component for Raise3D

Home Assistant is a DIY home automation platform. Currently, there are two Octoprint HA sensors that use the Octorprint Component for being able to pull data out of the printer and into HA. Can Raise3D put some effort into developing these features for Home Assistant? If your API is very similar to...
by poldim
Thu Jan 03, 2019 8:28 pm
Forum: Printing Settings
Topic: Printing directly on the bed without a RAFT?
Replies: 7
Views: 1083

Printing directly on the bed without a RAFT?

I'm still on my original filament that came with my N2. Everything I've tried to do to print without the RAFT does not seem to be working and it's adding a lot of time to the overall build. I'd like to figure out how I can print without it. If you are successfully printing without the raft , can you...
by poldim
Thu Aug 02, 2018 7:52 pm
Forum: Hardware
Topic: what happened to the the Official Raise3d Camera?
Replies: 45
Views: 12228

Re: what happened to the the Official Raise3d Camera?

So where is this camera circa 2016?
by poldim
Thu Aug 02, 2018 7:48 pm
Forum: Hardware
Topic: Permanent OCTOPRINT use?
Replies: 0
Views: 660

Permanent OCTOPRINT use?

So in this thread , they outline that Octoprint can be used without the touchscreen on the base hardware. Can you set it up such that the printer ALWAYS boots into Octoprint instead of having to SSH in, kill TS process, and launch OP? Is the USB port on top of the N2 connected to the system? Can it ...

Go to advanced search