Search found 4 matches

by hab
Thu Nov 28, 2019 6:55 am
Forum: Pro2 Series
Topic: z probe/sensor upgrade
Replies: 23
Views: 6028

Re: z probe/sensor upgrade

This is the key reason that I am Abandoning Raise3D PRO. A low cost fix the BLtouch is available. They could either provide it as an upgrade or open the source code and let the user community do it. I use the BLTouch on 5 different printers and will now only purchase printers that have it available....
by hab
Sat Sep 29, 2018 6:45 pm
Forum: Pro2 Series
Topic: Repeated error during boot
Replies: 1
Views: 697

Repeated error during boot

During boot I keep getting the attached error screen. I have been unsuccessful in clearing the problem. I can only proceed in safe mode which does not give access to any control screens.
Please assist!
by hab
Sun Sep 16, 2018 7:10 pm
Forum: Pro2 Series
Topic: Cold nozzles reading 240° C
Replies: 95
Views: 26289

Re: Cold nozzles reading 240° C

On my pro2 I can see cold temperatures that vary from 50C to 250C. I usually do something about it before It would get that high. The only time I have seen 330C is when I deliberately disconnected a thermocouple. My fix is re-plugging the 14pin connector on the amplifier board. I expect this to wear...
by hab
Sun Sep 16, 2018 7:02 pm
Forum: Pro2 Series
Topic: Cold nozzles reading 240° C
Replies: 95
Views: 26289

Re: Cold nozzles reading 240° C

I own a Pro2. I first opened a ticket about wild temperature swings on June 19th. This also led to extruder jams and failed prints. I finally traced this to the 14pin connector and after re-plugging, it I had several successful prints. The next ticket I opened was about the filament sensor sending f...

Go to advanced search