Search found 4 matches

by RGB_KGB
Fri Sep 07, 2018 2:26 pm
Forum: Hardware
Topic: Replacement Front Door
Replies: 2
Views: 514

Replacement Front Door

Hi Raise3D community,
I was curious if anyone else had issues with the N2 plus front door. The metal frame has become de-laminated from the acrylic. I tried using an epoxy to glue the frame back but it looks pretty sloppy. Is there a replacement door I can get?
by RGB_KGB
Wed Apr 11, 2018 7:04 pm
Forum: Printing Settings
Topic: Z Hop not working on 1st layer
Replies: 3
Views: 593

Re: Z Hop not working on 1st layer

Vicky,
Thank you for pointing that setting out. That got changed by mistake so I must have overlooked it previously. The Prints are coming out quite nicely with that issue fixed!
by RGB_KGB
Mon Apr 09, 2018 3:23 pm
Forum: Printing Settings
Topic: Z Hop not working on 1st layer
Replies: 3
Views: 593

Re: Z Hop not working on 1st layer

Have you ever check with the retraction points under preview? The Z hop is related to retraction. Every time when retraction happens, it will enable a Z hop. Please check your retraction settings, such as Avoid Retraction inside Model. I'll definitely look at this setting. I wasn't sure of the purp...
by RGB_KGB
Fri Apr 06, 2018 2:37 pm
Forum: Printing Settings
Topic: Z Hop not working on 1st layer
Replies: 3
Views: 593

Z Hop not working on 1st layer

Hello all, I've been looking through the forum and found how to change the Z-Hop settings for my prints, however, all the prints I do aren't adhering to using the Z-Hop. After the first level on the build plate I am getting lines that look like leaking. I've changed the retraction rate and Z-Hop and...

Go to advanced search