Feature Request: restrict travel to inside model

Raise3D is always hearing. If you have a feature requested related to our product, or if you have new ideas that need attention from the community, please post here.
Harlequin
Posts: 3
Joined: Thu Mar 29, 2018 3:13 am

Feature Request: restrict travel to inside model

Postby Harlequin » Fri Jul 06, 2018 11:29 am

Currently the slicer will move the nozzle over the outer shell of the model even if there is an option to keep the nozzle inside the model is it is the short distance. This increases retractions but also increases stringing, especially when dealing with flex.

Feature request:
Travel must remain inside model where possible up to "x" times the shortest path.

So if the shorted path was a 10mm travel which crossed the shell it would travel up to 50mm inside the model to reach its destination if X was set to 5

User avatar
Vicky@Raise3D
Posts: 3716
Joined: Fri Mar 25, 2016 3:54 am

Re: Feature Request: restrict travel to inside model

Postby Vicky@Raise3D » Wed Jul 11, 2018 6:49 am

Note taken. Will ask the software team to pay attention to.


Return to “Feature requests, ideas, wishes”

Who is online

Users browsing this forum: No registered users and 1 guest