Currently the slicer will move the nozzle over the outer shell of the model even if there is an option to keep the nozzle inside the model is it is the short distance. This increases retractions but also increases stringing, especially when dealing with flex.
Travel must remain inside model where possible up to "x" times the shortest path.
So if the shorted path was a 10mm travel which crossed the shell it would travel up to 50mm inside the model to reach its destination if X was set to 5
Raise3D is always hearing. If you have a feature requested related to our product, or if you have new ideas that need attention from the community, please post here.
2 posts • Page 1 of 1
Note taken. Will ask the software team to pay attention to.
Who is online
Users browsing this forum: No registered users and 1 guest