This might be a stupid question, but I am currently making a guide/walk through of how to change the filament nozzle, etc... So other people at our office can use the 3D Printer.
But I would like to have a clear screenshot of the screen, but when you connect to the 3D printer through IdeaMaker then I cannot access all screens like I can when I am physically at the 3D printer.
For instance, when I am at the Utilities screen I do not get the "load" and "unload" boxes (see picture) and this is crucual for the guide. And when I just take a picture of the screen it is very blurry and it has a lot of glare.
So long story short does somebody from Raise have some good screenshot (or pictures) of the screens that pop up when you load the filament and unload it?
Thanks in advance!
Any topics that don't fall into above categories. Please note that your thread may be moved to other discussion boards.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests