I was doing great with my new print surface (filafarm Switch/Filaprint). Printing up a storm. Loving ideaMaker.
Then I did something. Changed a setting or something and now I can't print anything I sliced the last 3 days. I was pulling my hair out, ready to quit. Photo with white filament messed up.
Then I decided to try a print that I sliced a few weeks ago and wala! it's printing. (small bathtub boat) .
Problem is I have no idea what I might have changed. Is there any settings available I can get or does anyone have any suggestions?
Discussions about ideaMaker and other printing software.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests