Usually I spend a lot of time before print, playing with fine-tuning profile and counting time of print.
Specially a lot of time needed if any special important area of print.
The idea is to have a window to compare print simulations (it is using in some photo apps like Photomechanic)And it's a good place to easily tune some settings too.
It's a consept image, just to illustrate.
Another idea (realized in Solidworks) - to add "Play button" to autoplay print and extruder movement for extra check.
Please post your suggestions for software changes here
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests