Printing with z-ultrat

Thoughts about Raise3D, 3D printing and making in general.
RiserDog
Posts: 65
Joined: Sat Jul 16, 2016 8:20 pm

Printing with z-ultrat

Postby RiserDog » Mon Aug 07, 2017 2:16 pm

Anyone ever tried Zortrax Z-Ultrat on a Raise n2plus? If you did not know it is an enhanced ABS that is stronger and can higher temps than regular ABS. It has been warp free for me so far but my flat tops have irregularities aka tiny marks where the extruder does not push out the filament smoothly enough. Maybe I should just use Raise ABS. ;)

User avatar
Mecha_Monster
Posts: 134
Joined: Wed May 11, 2016 2:07 am
Location: Mexico
Contact:

Re: Printing with z-ultrat

Postby Mecha_Monster » Mon Aug 07, 2017 2:45 pm

I have been curious about using Zostrax material, can you please post pictures of your print?.

I have been working with IC3D ABS, and so far it have performed very very well. Do you recommend trying Z-Ultrat?

RiserDog
Posts: 65
Joined: Sat Jul 16, 2016 8:20 pm

Re: Printing with z-ultrat

Postby RiserDog » Sat Aug 12, 2017 6:45 pm

Mixed results so far. Sides are great, top and bottom not so great. I get tiny little skips on the flat tops and flat bottoms. The one on the left is ultrat.

https://www.dropbox.com/s/7sxpg1ubcii31b4/ultrat.jpg?dl=0


Return to “General”

Who is online

Users browsing this forum: No registered users and 2 guests