Bondtech Vref 2nd Motor

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
ObjectiviTea
Posts: 15
Joined: Sat Mar 03, 2018 4:54 am

Bondtech Vref 2nd Motor

Postby ObjectiviTea » Sat Jan 12, 2019 11:02 pm

Bondtech installation has gone fine, however, it doesn't say at the end of the instructions which board potentiometer you are supposed to adjust for the second motor. There are two other boards.... I am guessing I only change the one below it? Help

User avatar
Vicky@Raise3D
Posts: 4687
Joined: Fri Mar 25, 2016 3:54 am

Re: Bondtech Vref 2nd Motor

Postby Vicky@Raise3D » Mon Jan 14, 2019 7:36 pm

There are five stepper drivers on motion board. The top two are for extruder motors. The top one is for Right Extruder and the one below is for Left Extruder. If you look it closely on board, you can find the terminals have been marked E1 and E0.
The drivers may have different color due to different batches, but which one for which motor are at the same position.
1.jpg


Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 4 guests