Board Error: Error:checksum mismatch...
-
- Posts: 6
- Joined: Mon Jun 25, 2018 12:48 pm
Board Error: Error:checksum mismatch...
I have an error that I will not clear. Does this indicate a bad board? It says check hardware but how are you supposed to know which hardware? Any ideas? Thanks

- Vicky@Raise3D
- Posts: 4815
- Joined: Fri Mar 25, 2016 3:54 am
Re: Board Error: Error:checksum mismatch...
It might be probably due to communication issue between screen board and motion controller board or something wrong with the gcode file.
Can you recreate the same issue with rebooting the power and print something with default settings?
Can you recreate the same issue with rebooting the power and print something with default settings?
-
- Posts: 6
- Joined: Mon Jun 25, 2018 12:48 pm
Re: Board Error: Error:checksum mismatch...
I changed the infill and it corrected the problem. Apparently it was the gcode. Thanks.
Who is online
Users browsing this forum: No registered users and 2 guests