Board Error: Error:checksum mismatch...

Thoughts about Raise3D, 3D printing and making in general.
Mike100370
Posts: 6
Joined: Mon Jun 25, 2018 12:48 pm

Board Error: Error:checksum mismatch...

Postby Mike100370 » Fri Oct 05, 2018 8:02 pm

I have an error that I will not clear. Does this indicate a bad board? It says check hardware but how are you supposed to know which hardware? Any ideas? Thanks

Image
Attachments
20181005_144314.jpg

User avatar
Vicky@Raise3D
Posts: 4563
Joined: Fri Mar 25, 2016 3:54 am

Re: Board Error: Error:checksum mismatch...

Postby Vicky@Raise3D » Sat Oct 06, 2018 1:31 am

It might be probably due to communication issue between screen board and motion controller board or something wrong with the gcode file.
Can you recreate the same issue with rebooting the power and print something with default settings?

Mike100370
Posts: 6
Joined: Mon Jun 25, 2018 12:48 pm

Re: Board Error: Error:checksum mismatch...

Postby Mike100370 » Mon Oct 08, 2018 2:34 pm

I changed the infill and it corrected the problem. Apparently it was the gcode. Thanks.


Return to “General”

Who is online

Users browsing this forum: EldRick and 2 guests