I use my printer not only for work related stuff, I make a lot of toys, figurines and mask, just for fun. It is already my biggest hobby.
Attached is an image of some of those prints, I will upload more in the following days.
Material: all of them ABS (Hatchbox)
Extruder temp: 236, heathbead temp: 110
Layer size: .25mm
Shell: 3 layers
Support: Abundant, and 6 layers of Dense support.
Bed: PEI sheet (I give up on Buildtak, it just doesnt work, no matter what. PEI sheets works like charm)
Post processing: I glue the parts using gorilla super glue (ideal), repair imperfection with sanding + bondo filler, and used Oil paints (same used for house interior)
Show off your prints, mods, etc.
2 posts • Page 1 of 1
Very cool. Nice work mate.
Who is online
Users browsing this forum: AFTECH and 1 guest