Extruder gears disassembly

Shelton
Posts: 330
Joined: Thu Jul 12, 2018 8:34 pm

Extruder gears disassembly

Postby Shelton » Tue Aug 14, 2018 7:12 pm

How to disassembly extruder gears. I have terrible jam and I need tear it on pieces it. Do you have any service manual abou this?

User avatar
Vicky@Raise3D
Posts: 4564
Joined: Fri Mar 25, 2016 3:54 am

Re: Extruder gears disassembly

Postby Vicky@Raise3D » Wed Aug 15, 2018 12:36 am

Have you ever tried with opening the side panel and using tweezers to remove the filament inside?
1.png
1.png (132.81 KiB) Viewed 338 times

Shelton
Posts: 330
Joined: Thu Jul 12, 2018 8:34 pm

Re: Extruder gears disassembly

Postby Shelton » Wed Aug 15, 2018 7:10 am

Yes but something stuck lower under the gears in throat tube...

User avatar
Vicky@Raise3D
Posts: 4564
Joined: Fri Mar 25, 2016 3:54 am

Re: Extruder gears disassembly

Postby Vicky@Raise3D » Wed Aug 15, 2018 5:56 pm

If you can reach the filament with extruder removed?
1.png

Shelton
Posts: 330
Joined: Thu Jul 12, 2018 8:34 pm

Re: Extruder gears disassembly

Postby Shelton » Wed Aug 15, 2018 6:43 pm

Blocked in lower part of extruder.

User avatar
Vicky@Raise3D
Posts: 4564
Joined: Fri Mar 25, 2016 3:54 am

Re: Extruder gears disassembly

Postby Vicky@Raise3D » Thu Aug 16, 2018 6:53 pm

Take the extruder off from the printer with the four screws marked above.
Remove the three fixing screws from front and back of the , one side has two, one side has one. Then you can open the extruder.

Shelton
Posts: 330
Joined: Thu Jul 12, 2018 8:34 pm

Re: Extruder gears disassembly

Postby Shelton » Thu Aug 16, 2018 6:56 pm

Yes, I need to do it this way only. I tried by cleaning rod but without success.


Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 3 guests