Topics around mechanical design, controller and electronics. Mods & hacks welcome.
4 posts • Page 1 of 1
I am also interested in venting the N2Plus to the outside of the office where I print. To calculate fan size use CFM (cubic feet per minute). Example: N2Plus enclosure is roughly 2'x2'x3'. or 12ft^3. Find a fan with a CFM rating of 12 and you will be "purging" the air in the enclosure once every minute. Im thinking that 2x or 3x a minute is better, but i am worried about the slightly cooler air warping prints. I will update asap.
If ABS is printed it is good if the interior is heated up to 60-70 °. As a result, the delamination and premature separation from the building panel is clearly prevented. In my opinion, no additional ventilation is required with ABS, as well as the fans on the print head should be closed with the small covers.
Who is online
Users browsing this forum: No registered users and 3 guests