Don't know if this is a serious challenge or not, but I think it shows that Raise3D printers are among the best in printing precision.
No other FDM printer (besides my N1) have reported a successful print of this spinner:
One guy reported success on a Stratasys Objet, but other FDM printers only managed to do the 0.20, 0.15 or 0.10 mm clearance, even Ultimakers.
My N1 printed the part perfectly in first shot. The most challenging 0.05 wheel came loose after a little wrenching and now moves freely without any noticeable play:
Just for fun
Show off your prints, mods, etc.
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest