Retraction on travel moves please help

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Mustachio
Posts: 5
Joined: Wed Jun 13, 2018 5:11 am

Retraction on travel moves please help

Postby Mustachio » Sat Jun 16, 2018 5:44 pm

How do I make idea maker retract on travel moves? Right now it just stops extruding on travel moves and does not retract.
Please help!!

User avatar
Vicky@Raise3D
Posts: 3754
Joined: Fri Mar 25, 2016 3:54 am

Re: Retraction on travel moves please help

Postby Vicky@Raise3D » Sun Jun 17, 2018 7:45 am

Please check the preview in ideaMaker of your gcode. The points marked as red forks are retraction points.
1.png

Normally by default, retraction is triggered before each long movement. You can check whether in ideaMaker whether the retraction points are enabled properly or not.


Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 1 guest