Page 1 of 1

Ideamaker under extrusion

Posted: Wed Jun 13, 2018 2:27 pm
by Mustachio
Ive been having trouble with under extrusion. Been using fixed starting point at the back left corner. Seems like as the nozzle moves back through the infil it pulls filament out so I get under extrusion at the start of each outside lines. Ive tried checking and unchecking Avoid retraction, zhop .2 3 4 and 5. Anyone now why this is happening. Its not a clog. Happens on both of my printers with different filament.