I've been fighting some quality issues lately. I got the printer and it was printing fine for awhile, but then the printer got moved. I was not the one to move it, but something happened and my print quality is no longer good. The printer and the bed is level, the homing screw has the bed at 0.2 with the provided shim. I put a new extruder assembly in, so it shouldn't be clogged Every time I print something, the top layer is unfinished and has gaps as shown in the pictures. I printed a Benchy, and it didn't turn out well, as shown in the pictures as well. Everything I try doesn't seem to improve the quality.
Any help is appreciated!
Printer Quality Help
Re: Printer Quality Help
This link should give you all the info you need about most quality issues.
https://www.simplify3d.com/support/print-quality-troubleshooting/#not-extruding-enough-plastic
https://www.simplify3d.com/support/print-quality-troubleshooting/#not-extruding-enough-plastic
- John
2 Raise3D N2 Duals, Bondtech BMGs, adjustable table, Panucatt SD2224 drivers, run-out sensor, thermal overload protection, Firmware 1.1.9ABH - with Lin_Advance, Palette 2 Pro, Custom E3D hot end and ultra-light carriage and printer head
2 Raise3D N2 Duals, Bondtech BMGs, adjustable table, Panucatt SD2224 drivers, run-out sensor, thermal overload protection, Firmware 1.1.9ABH - with Lin_Advance, Palette 2 Pro, Custom E3D hot end and ultra-light carriage and printer head
Who is online
Users browsing this forum: No registered users and 2 guests