Printer Quality Help

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
mikebrown4199
Posts: 1
Joined: Wed Jun 06, 2018 5:15 pm

Printer Quality Help

Postby mikebrown4199 » Wed Jun 06, 2018 5:44 pm

I've been fighting some quality issues lately. I got the printer and it was printing fine for awhile, but then the printer got moved. I was not the one to move it, but something happened and my print quality is no longer good. The printer and the bed is level, the homing screw has the bed at 0.2 with the provided shim. I put a new extruder assembly in, so it shouldn't be clogged Every time I print something, the top layer is unfinished and has gaps as shown in the pictures. I printed a Benchy, and it didn't turn out well, as shown in the pictures as well. Everything I try doesn't seem to improve the quality.

Any help is appreciated!

20180606_132512.jpg

20180606_132515.jpg

20180606_132529.jpg

20180606_132544.jpg

20180606_132551.jpg

User avatar
JohnSays
Posts: 638
Joined: Tue Apr 26, 2016 2:42 pm
Location: Saint Petersburg, FL

Re: Printer Quality Help

Postby JohnSays » Sat Jun 30, 2018 7:45 pm

This link should give you all the info you need about most quality issues.

https://www.simplify3d.com/support/print-quality-troubleshooting/#not-extruding-enough-plastic
- John
2 Raise3D N2 Duals, V2 nozzles, Bondtech BMGs, adjustable table, Panucatt SD2224 drivers, run-out sensor, thermal overload protection resistors on motion controller board, Firmware 1.1.8ABH - with Lin_Advance, Palette+


Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests