I've bought 1kg of PrimaSelect Flex filament (http://www.primafilaments.com/product/primaselect-flex/)
So far managed to print it with these settings:
Bare, clean glass. Not spray, glue or anything.
Printer Anet A6 (default electronics, some frame modding, Marlin 1.1.8)
Bed temp 90c
Nozzle 230c (0.4mm)
1st layer 8mms with 104% flowrate (extra flow for better adhension) and 0.3mm thickness
Rest of layers 0.2mm thickness
Default printspeed 35mms
Inner shell 35mms
Outer shell 25mms
Movement speed 50mms
Retraction 2mm, 40mms, no zhop or extra retraction amount on start.
No cooling, HUGE brim (like 30-50 rounds).
Took me many prints to find these settings, hope these will give some of you basic setup where start tweaking them
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests