I did a print yesterday. And the nozzle started hitting the supports. So I lowered the flowrate on the printer from 94 to 92%.
And that caused the finish of the printed PLA to change from glossy to matte.
(I get the same glossy/matte finish difference on PLA if I print with different temps).
Does lowering flow rate make the plastic "linger" longer in the nozzle/throat and therefore get more cooling? And extruding colder.
Or is something else in play here?
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests