I recently installed Bondtechs on my N2Plus. I'm using a .6 mm nozzle and I've had good results printing with NylonX. I switched in Hatchbox ABS and the print runs fine for about half an hour 'till the extruder starts clicking and the AS stops flowing. The nozzle isn't clogging, instead filament seems to be thickening before it goes into the wheels until they can't push it through anymore. If I remove the filament and cut off the thick section, it runs well for another half hour and then stops again. Any suggestions?
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests