I've been attempting to print with PC-Plus and found the suggested settings yielded tons of blobs, stringing and quick failure.
I'm using a Raise3D N2 unit and have lowered my printing temps and added more aggressive retraction, however I'm still getting lots of stringing which leads to a mess.
Layer height: 0.1mm
Plate: Builtak @ 110c - was required to stick
Hotend: Have moved down to 245c, still stringing though
Retraction: 6mm @ 60mm/s, showed a small improvement.
Any suggestions would be highly appreciated. Is it possible this material doesn't like fine layers?
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests