Polymaker PC-Plus trouble

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Posts: 1
Joined: Mon Feb 12, 2018 6:15 pm

Polymaker PC-Plus trouble

Postby tylerfoy » Mon Feb 12, 2018 6:20 pm

I've been attempting to print with PC-Plus and found the suggested settings yielded tons of blobs, stringing and quick failure.

I'm using a Raise3D N2 unit and have lowered my printing temps and added more aggressive retraction, however I'm still getting lots of stringing which leads to a mess.

Layer height: 0.1mm
Plate: Builtak @ 110c - was required to stick
Hotend: Have moved down to 245c, still stringing though
Speed: 40-50mm/s
Retraction: 6mm @ 60mm/s, showed a small improvement.

Any suggestions would be highly appreciated. Is it possible this material doesn't like fine layers?

Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests