Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Posts: 7
Joined: Sat Jan 20, 2018 12:22 pm


Postby jpson67 » Sun Jan 21, 2018 11:54 am

What is wrong when the objekt get this posistion and not in the center of buildplate, it's in the center in ideamaker

User avatar
Posts: 4815
Joined: Fri Mar 25, 2016 3:54 am

Re: Posistion

Postby Vicky@Raise3D » Mon Jan 22, 2018 2:31 am

The real size of N1 printing surface is 236mm*256mm. Since the printing size for N1 is 205mm*205mm and the origin point of the horizontal direction is at left front corner, there will have 31mm in X at right side and 51mm in Y at rear side where the left nozzle cannot reach from 0-205mm.
The 31mm in X is due to there has 25mm offset between left and right nozzle at X direction, and the 6mm is for buffer due to cooling fan and extruder and motor size.
The 51mm in Y is due to the extruder and extruder motors, if move too far, they will hit the boundary.

Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 5 guests