PETG stringing

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Posts: 13
Joined: Mon Dec 04, 2017 1:10 pm

PETG stringing

Postby Shane » Mon Jan 08, 2018 9:10 pm

Hi, my PETG prints - when they complete - generally look OK, but some strings are occurring and I can see some blobs on print surface which I'd liek to avoid.

Please can anyone advice on print settings, for ooze etc. I'm using Raise3D PETG standard profile

many thanks
but generally the exterior surfaces are fine.
and on the other
some strings on one corner

Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests