I've used conductive filament (ABS) with a MakerBots Replicator 2X, however now my project is bigger than before and I need a bigger printer too. I will use a Raise 3D N2 and I've the doubt if is there any kind of restriction to conductive filament? Can I use the same ABS, or there is any recommendation from the Raise3D about conductive filament?
Thanks in advance,
Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests